Arduino + shield

Shield with RF module added
Shield with RF module added

So this project had been sitting on my desk for ages now with the sensors and RF module spread across two breadboards with a mess of wire connecting it all up. Today I finally found some time to add the RF module to a prototyping shield. The other sensors are still on a breadboard and that’s the extra wires hanging off it, but it’s one step closer to a finished project. Some of the soldering was a bit fiddly but worked straight off.

One thought on “Arduino + shield”

  1. With those four pins soldered, try plugging the shield into your Arduino to test the header s alignment. Make sure your Arduino s not powered while you do this alignment check.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.